Atik 16IC auto guider

[Forum_2015]

I am attempting to use the Atik 16IC as an auto-guider using the Astro Art plug-in supplied by Atik but I can't get the internal ST-4 connector to move my CGE mount. I tried selecting the Artemis relays and it indicated it is connected. Do I need to use the ASCOM driver for the 16IC? The 16IC works with PHD2 so I know the camera and mount are OK. What am I missing???

The main camera is my Atik 383L+OSC

Thanks

John
CCD-Freak

[Forum_2015]

John, with my setup in the "Telescope Control" setup tab I select "Camera 2 relays" to use my guiders st4 port. I hope this helps.

Iver

[Forum_2015]

Thanks Iver....I don't remember if that came up as an option but I will check again and try that if it is in the list. Hope it works.

John
CCD-Freak

[Forum_2015]

Here is a screen shot if this helps.

Iver