Astroart Forum

When show a flat frame in Asiair I see a little artifact from the sensor. It's show up in the upper right corner at the sub frame.
When I open the fits in AA8 the artifact are now in the lower right corner of the picture.
Why is that? . Asiair nor AA8 know how the picture was taken. Mount turned off, no plate solve.
And I gess dark frame is the same.
Should I just forget and hope light, Darks, Flats come out nicely

I don't know witch way is the correct way, yet.

Hi, probably all lights, flats and darks FITS files are incorrectly saved vertically flipped, but you can safely preprocess the whole sequence and flip the result after preprocessing.
To avoid the problem, you could ask the software manufacturer to support the ROWORDER keyword, see:
https://free-astro.org/index.php?title= ... rientation

If ROWORDER is not present, Astroart 8 uses the correct FITS orientation (bottom-up). You can verify the correctness opening your images with any FITS viewer, see:
https://fits.gsfc.nasa.gov/fits_viewer.html (I recommend DS9)

Using the correct FITS orientation guarantees that if you make a discover and you send the image to a professional observatory or institute, it will be displayed as you intended, since all academic software under Unix/Linux uses the same FITS orientation (bottom-up).

A quick on-line viewer to verify FITS files:
https://www.clearskyinstitute.com/fits/fits.html
Fabio.

Great info Fabio.
I will inspect the Asiair fits for ROWORDER bottom up.
If needed I could insert the code by a macro.

OK, actually ROWORDER "top-down" is fine as well.
The problem is when ROWORDER is completely missing.
Clear skies, Fabio.