Astroart Forum

Hello Everyone,

I wrote the auto-pilot script commands, example as follows :

exposuretime = 60
DDR$="d:/Test"
createdir(DDR$)
DDR$=DDR$+"/"
n = Telescope.List.Count
Guider.Select(2)
Wheel.Goto(1)
for i = 1 to n
ra = Telescope.List.Ra(i)
de = Telescope.List.Dec(i)
name$ = Telescope.List.Name$(i)
Telescope.Goto(ra,de)
Telescope.Wait
Pause(20)
Camera.StartAutoguide()
Camera.Start(exposuretime)
Camera.Wait
Camera.StopAutoguide()
Image.Save(DDR$ + name$ + ".fit")
Image.close
next i

In this case, it shew auto-guided screen on my PC every exposing shot.
How to close auto-guided sub-screen every shot ?

It looks like you are using an older user interface (Guider.Select) is not needed with the new interface, (Camera.StopAutoguide) may not be supported in the UI you are using.Try using (Guider.Close)

To close an open image use "Image.Close" this will close the active image, so it must be run for each open image.